I recently posted
this thread asking about the floors of shooters this year.
This thread is to discuss what teams did on the wall opposite their shooter wheels. I have seen some people do HDPE, some rubber, some roughtop tread. What did your teams do to get the desirable spin/ speed on the frisbee?
Also, the total amount of compression you put on the frisbee would also be helpful.
Thank you!
__________________
(Hanging out with my buddies at
610)
Robotics, it's not just a club, it's a career.
FLL Referee (2012-Present)
2014 Gateway Robotics Challenge winners (With 2481 and
1985)
2011 St. Louis Regional Winners (With 1985 and 3284)
2010 Highest Rookie Seed
I am the guy in the golden hat, say "Hi!" to me at WORLD CHAMPIONSHIPS!!!
You pick the best person for the job whether they are black, white, asian, hispanic, female, or male; NOT so you 'look good' when they publish your team picture in the school paper, but because they can get the job done right, on time, with a passion. - Pavan Dave [more] 
Threaded Mode