Stepper Driver to CIM - Chief Delphi

a big part of FIRST is to educate everyone, even those "stupid freshmen" about science and technology. - Beth Sweet [more]

		Chief Delphi > Technical > Motors
Stepper Driver to CIM

Thread Tools

Rate Thread

Display Modes

#12

08-19-2013, 12:57 AM

daniel_dsouza daniel_dsouza is offline

does what needs to be done.

FRC #2449 (Out of Orbit Robotics)

Team Role: Alumni

Join Date: May 2011

Rookie Year: 2011

Location: Chandler, AZ

Posts: 231

daniel_dsouza has a spectacular aura about

Re: Stepper Driver to CIM

So say that you do decide to use CIMS...

What would your electronics setup look like. Do you have a specific set of encoders in mind? What board will interface between the motors and PC CAM software?

There was someone who used CIM motors to make a 3D printer that printed concrete...That was some time back.

Your posts are like poetry...take it or leave it.

« Previous Thread | Portal | Next Thread »

Thread Tools
Show Printable Version Email this Page
Display Modes	Rate This Thread
Switch to Linear Mode Switch to Hybrid Mode Threaded Mode	Rate This Thread:

Posting Rules
You may not post new threads You may not post replies You may not post attachments You may not edit your posts vB code is On Smilies are On [IMG] code is On HTML code is Off

Forum Jump

All times are GMT -5. The time now is 03:10 PM.

The Chief Delphi Forums are sponsored by Innovation First International, Inc.