WCD-Belt Driven CAD practice

[ablatner]

Originally Posted by Cash4587

http://prntscr.com/1m25qt

Yet again, I did some more updating to make the bumper mounts legal (the distance between them was not <= 8in.) and I made their flanges beefier. Lastly, I widened the frame an inch and a half on each of the end tubes to better use all of the frame perimeter rule except 1 inch of it. so the frame perimeter is now 111" vs 108"

I can't quite tell from the angle, but is there enough room for mounting hardware on the bumper mount flanges? The sets of holes on the inside of the flange look really close to the bend. You may not be able to get a rivet gun in there.