WCD-Belt Driven CAD practice

Bumper quality is an "attention to detail" measure. Teams that get little things right tend to do better on the big things. - vhcook [more]

		Chief Delphi > FIRST > General Forum
WCD-Belt Driven CAD practice

#22

21-08-2013, 20:44

ptitchener ptitchener is offline

Registered User

FRC #3205

Join Date: Jan 2010

Location: Concord, MA

Posts: 14

Re: WCD-Belt Driven CAD practice

The weight seems a little low to me - you should check if your CIMs are set to 2.5 lbs each/wheels etc. If it is right, how did you get it so low?

Thread Tools
Show Printable Version Email this Page
Display Modes	Rate This Thread
Switch to Linear Mode Switch to Hybrid Mode Threaded Mode	Rate This Thread:

Posting Rules
You may not post new threads You may not post replies You may not post attachments You may not edit your posts vB code is On Smilies are On [IMG] code is On HTML code is Off

Forum Jump

All times are GMT -5. The time now is 21:16.

The Chief Delphi Forums are sponsored by Innovation First International, Inc.