Team 254 Presents: 2013 Build Blog

[Travis Covington]

Originally Posted by ttldomination

That looks mighty...sketchy. I suppose the fact that so many people use this method speaks to its validity, but doesn't the encoder want to spin with the axle? While I expect that the zipped down wires help some of that, I can't help but think that there's a little wiggle in there.

- Sunny G.

These are the ball bearing S4 encoders. This will not work with the bushing ones. We do not use the bushing ones anywhere. We typically hot glue the connector and add additional strain relief to the wire to prevent damage to the wire/connector. If done properly there is no "wiggle" as the bearing drag is the only friction that exists and is quite minimal. We have done this (on 254/968) for as long as I can remember using encoders (nearly 10 years now).