LabVIEW, have throttle run motor?

[jman4747]

Thanks that looks good. I,ll try it and see. The only other thing I was worried about with this section of the code was if the axis 3's output numbers were 0-1 or not and if I needed to put an algorithm in between the axis 3 output and the set motor input so set motor did the right thing with it.

[Ether]

Originally Posted by jman4747

The only other thing I was worried about with this section of the code was ... if I needed to put an algorithm in between the axis 3 output and the set motor

If so, break the wire at the red arrow and insert your code there.