Communication issues?

[ekapalka]

You said the problems started when you downloaded new code. Are you sure you put the correct, and functioning, code on the robot?

I'm sure that the code functions. I stripped the entire code down to the bare minimum for driving

LabVIEW, Java, or C++?

The code I downloaded was C++, and so was the code prior to re-imaging the cRIO

What do you mean by "switched the target server to the proper one"?

In WindRiver, you have to select the target depending on weather you are using a cRIO or cRIO-II (I'm not 100% sure of the terminology... I'm working from memory)

Does the Robot Signal Light show the correct slow blink when the robot is enabled for teleop? (on for approx. 3 seconds, off for approx. 0.5 seconds)

Is that a light on the cRIO? The only light whose blinking patterns I can remember are the ones on the Talons (orange, same time on as off; Pretty sure it should be solid orange when enabled). I appreciate the response :)