2 CIM Swerve Concept - Chief Delphi

Maybe my brain fog factor has expanded after wading through 1114's competition data sheet, so I cannot see the forest for the trees. - Bill_B [more]

		Chief Delphi > Technical > Technical Discussion
2 CIM Swerve Concept

Thread Tools

Rate Thread

Display Modes

14-10-2013, 13:38

Nate Laverdure Nate Laverdure is offline

Registered User

FRC #2363

Team Role: Coach

Join Date: Apr 2005

Rookie Year: 1999

Location: Newport News, VA

Posts: 831

Nate Laverdure has a reputation beyond repute

Re: 2 CIM Swerve Concept

Quote:

Originally Posted by magnets

...an 8mm shaft coupling...

The keyway in the CIM output shaft does not go all the way to the end (pdf link). You could mill flat spots in the shaft to provide landing areas for the set screws on your shaft coupling, but I'd expect this to be a point of failure.

__________________
Cryogenics mechanical engineer, Thomas Jefferson National Accelerator Facility (JLab)

« Previous Thread | Portal | Next Thread »

Thread Tools
Show Printable Version Email this Page
Display Modes	Rate This Thread
Switch to Linear Mode Switch to Hybrid Mode Threaded Mode	Rate This Thread:

Posting Rules
You may not post new threads You may not post replies You may not post attachments You may not edit your posts vB code is On Smilies are On [IMG] code is On HTML code is Off

Forum Jump

All times are GMT -5. The time now is 12:44.

The Chief Delphi Forums are sponsored by Innovation First International, Inc.