Talon PWM Questions (Independent Project)

[Ether]

Some data and calculations to support my previous post:

For the Jag, the schematic is available. The turn-on threshold is 1.6ma max. The silicon drop across the LED is approx 1.2V at 3ma. There's a 150 ohm series resistor. So to push 3ma thru the Jag's input would require 1.2+0.003*150=1.65 volts at the input.

For the Vic, I have some test data.

So if the 3.3 volt source is low impedance, it will most likely work just fine.