|
|
|
 Don't forget the robot, the most important hardware there is!:p - artK [more] |
 |
|
|||||||
|
||||||||
 |
|
|
Thread Tools | Rate Thread | Display Modes |
|
|
|
| Don't forget the robot, the most important hardware there is!:p - artK [more] |
|
|
|||||||
|
||||||||
|
|
|
Thread Tools | Rate Thread | Display Modes |
|
|
|
#1
|
|||
|
|||
|
Re: [FTC]: Couldn't connect to Samantha
The flashing white light indicates the samantha has the right password to connect to your router. Did you set the router to Wireless B only? For some routers, you also need to set the wireless data rate and transmission speed to 2 Mbps.
|
|
#2
08-11-2013, 21:31
|
|||
|
|||
|
Re: [FTC]: Couldn't connect to Samantha
Yes, I set the Wireless B only. The router I am using is Linksys E1200.
|
|
#3
11-11-2013, 11:22
|
|||
|
|||
|
Re: [FTC]: Couldn't connect to Samantha
Here are a few other ideas:
1. Did you change the router IP address to 192.168.2.1? 2. Did you set the Internet Connection Type to Automatic Configuration - DHCP? 3. Can you run the samostat program on your NXT brick? What is the IP address?
|
|
| Thread Tools | |
| Display Modes | Rate This Thread |
|
|
Hybrid Mode
