Quote:
Originally Posted by Jason Spurlock
Hi, I'm a mentor from Team 313 - The Bionic Zebras, and now I'm participating in a college robotics club and we want to use the FIRST power distribution board, but the robot we want to build has motors that run off of 24 volts. What would happen if we put 24 volts through the power distribution board? The spec sheet for the power distribution board says that it can take 6-15 Volts. We do not know why there is a operating voltage range because we are assuming all the grounds are internally connected and all the positive power is internally connected so voltage should not matter, right?
|
EricVanWyk designed the PDB I believe. You might try sending him a Private Message.
It's not GP, its not un-GP, its just a strategy. - AndyB [more] 
18-11-2013, 15:32
Threaded Mode