|
|
|
 (I'm sure that Dave is holding his breath for "welding with Jello".) - jgannon [more] |
 |
|
|||||||
|
||||||||
|
|
Thread Tools | Rate Thread | Display Modes |
|
|
|
| (I'm sure that Dave is holding his breath for "welding with Jello".) - jgannon [more] |
|
|
|||||||
|
||||||||
|
|
Thread Tools | Rate Thread | Display Modes |
|
#5
20-11-2013, 19:25
|
||||
|
||||
|
Re: Two Power Distribution boards?
I would expect it would be ruled as illegal. But that is just an opinion. That aside, two lugs on the studs of the PD board would be OK if there is enough clearance to the body. Otherwise splice the wires before PD board. I probably would use the same compression lugs, bolt them together & tape them.
|
| Thread Tools | |
| Display Modes | Rate This Thread |
|
|
Threaded Mode