|
|
|
 Go figure that by teaching you end up learning a lot through the process. ;) - Josh Fox [more] |
 |
|
|||||||
|
||||||||
 |
| Thread Tools | Rate Thread | Display Modes |
|
|
|
| Go figure that by teaching you end up learning a lot through the process. ;) - Josh Fox [more] |
|
|
|||||||
|
||||||||
|
| Thread Tools | Rate Thread | Display Modes |
|
#1
|
|||
|
|||
|
Power Terminals
Does anyone know where to find the 6AWG ring terminals?
Last edited by LeadRiccardoT : 07-02-2003 at 15:51. |
|
#2
07-02-2003, 16:17
|
|||||
|
|||||
|
can you be more specific are you talking about the ring connectors that are used to connect the leads of the battery to the battery and to connect the 6 awg wire to the fuse panel? if you are then you should be able to find them at any store with electrical connectors (IE. Radio shack, ACE Hardware, Lowes, etc) any store like that should carry them.
|
|
#3
07-02-2003, 16:36
|
||||
|
||||
|
If you ask for "Ring Terminals", they might look in the wrong rack and tell you that they don't have them. Most of the 6awg "ring terminals" that I've found are referred to as "Lugs". The only difference between them (as far as I can tell) are that "Lugs" do not have any insulation on them.
|
|
#4
08-02-2003, 09:41
|
|||||
|
|||||
|
You can find these crimp ons at Radio Shack in a pinch (they are more expensive) or even at Home Depot. Any hardware store or electrical supply will have them if you need them quick. Otherwise check out Digikey.
Also, when specifying terminals you have to say the wire size and the stud (hole in the terminal) size. Last edited by Al Skierkiewicz : 08-02-2003 at 09:46. |
|
#5
08-02-2003, 11:24
|
|||
|
|||
|
C&H Surplus in Pasadena, CA. (I'm not sure if they're on the web.) APEX in Sun Valley, CA. (not on the web) Possibly www.allelectronics.com
|
|
| Thread Tools | |
| Display Modes | Rate This Thread |
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| power to the pits | Ken Leung | Off-Season Events | 12 | 11-05-2003 22:48 |
| URGENT!! Need OI power brick specs for 7AM demo tomorrow!!! | kmcclary | Electrical | 8 | 10-10-2002 10:56 |
| power supply of control system | archiver | 2000 | 5 | 24-06-2002 00:14 |
| power of globe motor with gear box? | Ken Leung | Motors | 5 | 21-11-2001 13:43 |
| Max mechanical power of motors, how is it useful? | Ken Leung | Motors | 1 | 09-11-2001 14:15 |
Linear Mode
