|
|
|
Speaking about healthier, the Texas air was sooooooooo much cleaner than NJ air, I felt my life expectancy being extended another 5 years. - The Chinese Guy [more] |
 |
|
|||||||
|
||||||||
|
|
Thread Tools | Rate Thread | Display Modes |
|
|
|
|
Speaking about healthier, the Texas air was sooooooooo much cleaner than NJ air, I felt my life expectancy being extended another 5 years. - The Chinese Guy [more] |
|
|
|||||||
|
||||||||
|
|
Thread Tools | Rate Thread | Display Modes |
|
#1
|
||||
|
||||
|
Units for Pipe Measurements
Is it just me or are pipe nipple "inches" a different length than regular inches? Our team was measuring our 1 1/4" x 12" pipe nipples today for assembling our goal only to discover that no dimension on them was 1 1/4". The closest dimension was the ID which could be rounded down to 1 3/8". If they didn't screw into the flanges that are clearly labled 1 1/4, I would think we got the wrong pipe. What's going on here? Does anyone know what the OD of the pipes is supposed to be? I think this would be a pretty valuable number for any team to know since it's what we're going to be gripping on to, and in my experience it is NOT 1 1/4".
|
| Thread Tools | |
| Display Modes | Rate This Thread |
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| precise measurements in Inventor | ajlapp | Inventor | 6 | 12-09-2003 15:53 |
| 2002 Motor Measurements | Matt Krass | Motors | 5 | 06-08-2003 12:20 |
| Fun with units...... | Adam Y. | Math and Science | 9 | 22-01-2003 20:20 |
Threaded Mode