|
|
|
![]() |
|
|||||||
|
||||||||
|
|
Thread Tools |
Rating:
|
Display Modes |
|
#13
|
|||
|
|||
|
Re: Back for more..VEXpro 2014 Product Unveiling
Correct, the bearings are held entirely in the Versa-Block, so the wheel load is distributed evenly all along the top and bottom of the tube where it is clamped. The Versa-Block is by design, extremely robust, and the bearings are held .25" out from the tube, putting even less stress on the shaft/bearings then if the bearings were held inside the tube.
|
| Thread Tools | |
| Display Modes | Rate This Thread |
|
|