|
|
|
![]() |
|
|||||||
|
||||||||
|
|
Thread Tools |
Rating:
|
Display Modes |
|
#7
|
|||||
|
|||||
|
Re: What to know?
Adding to what others have said:
1. How to drill holes in metal. Safely. 2. How to cut metal. Safely. 3. How to measure distances, very accurately. Inches, down to much better than 1/32" (much less than 1/3 the width of a 'sharpie' line) 4. The proper usage of nuts, bolts, washers, lockwashers, locknuts, and thread locker fluid. Including 'tight' and 'too tight'. 5. The correct way to use a metal file. And safely. 6. Why "polycarbonate" (lexan) is used and "acrylic" (plexiglass) is not. Very important! AND, the MOST important thing to know: 7. How To Read. (Read <and obey> the rule book, often, or suffer the consequences) Good luck this season, come back often and search to find answers. Ask if you can't find what you need. |
| Thread Tools | |
| Display Modes | Rate This Thread |
|
|