|
|
|
 The most important deisgn criteria is always performance in any of the parts / systems we design. But we do try to abide by the saying -- if it doesn't look good (right), it probably isn't good (right). - Adam Freeman [more] |
 |
|
|||||||
|
||||||||
 |
|
|
Thread Tools | Rate Thread | Display Modes |
|
|
|
#1
|
|||
|
|||
|
Re: [FTC]: Help With AutoDesk Inventor 2012 ?
Ok, thanks @nemo and @mozrila.
Now our CAD of our bot is complete. We'd like to create a 360deg "flyover" view of the CAD bot. Is this possible to do in Inventor 2012? We have found tutorials on how to "explode" all the parts out and have them go back together, but none that show how to do a "flyover". Any ideas? Or not possible in Inventor 2012? thanks again for the help! - FTC 6389 
|
|
#2
26-12-2013, 18:42
|
||||
|
||||
|
Re: [FTC]: Help With AutoDesk Inventor 2012 ?
I have never used 2012, but in 2014 you would do it by using Inventor Studio and rendering an animation. Inventor Studio is in the environments tab.
|
|
#3
26-12-2013, 21:30
|
|||
|
|||
|
Re: [FTC]: Help With AutoDesk Inventor 2012 ?
Look into using any of the following:
autodesk 3DS max autodesk Maya Autodesk Showcase Autodesk Inventor Publisher We use Showcase and Publisher. I am also the designer and animator of these http://www.youtube.com/watch?v=plFgXn_BuCA http://www.youtube.com/watch?v=aPQINTKGGAY http://www.youtube.com/watch?v=T-J3G4m17kE
|
|
| Thread Tools | |
| Display Modes | Rate This Thread |
|
|
Hybrid Mode
