|
|
|
 There is always a way, you just have to find it. - Arefin Bari [more] |
 |
|
|||||||
|
||||||||
 |
|
|
Thread Tools |
Rating: 
|
Display Modes |
|
|
|
| There is always a way, you just have to find it. - Arefin Bari [more] |
|
|
|||||||
|
||||||||
|
|
|
Thread Tools |
Rating:
|
Display Modes |
|
|
|
#1
|
||||
|
||||
|
Re: Victor Blinking Light Question
I am aware of the calibration light, but I'm not calibrating the victor. There's no PWM signal going in, and it still flashes green, and you can't calibrate without a pwm signal.
|
|
#2
01-01-2014, 09:01
|
||||
|
||||
|
Re: Victor Blinking Light Question
I would start by removing anything that is connected to the output, disconnect the PWM, double check input wiring for 12 volts and apply power.
If it looks normal then try a cal without PWM and then with PWM. The results of the above tests will be very helpful to finding out what is wrong. |
|
| Thread Tools | |
| Display Modes | Rate This Thread |
|
|
Hybrid Mode
