|
|
|
![]() |
|
|||||||
|
||||||||
![]() |
| Thread Tools | Rate Thread | Display Modes |
|
#1
|
||||
|
||||
|
Battery Level as a Control in Labview
Hello everybody,
I was just wondering if the battery level (in volts) could somehow be used as a control to program other functions in Labview. Thanks |
|
#2
|
|||
|
|||
|
Re: Battery Level as a Control in Labview
Sure! There is a VI that will report the robot battery voltage (assuming a properly wired analog breakout board in slot 1) and you can use the number that is output from the VI to wire into any math or other VIs that you would like
|
|
#3
|
||||
|
||||
|
Re: Battery Level as a Control in Labview
Thanks!
Last edited by alexander.h : 05-01-2014 at 13:42. |
![]() |
| Thread Tools | |
| Display Modes | Rate This Thread |
|
|