|
|
|
 Just keep doing. Everything. Keep designing, keep building, keep learning, keep fundraising. Build more robots, try more ideas, compete more and more and more. - [more] |
 |
|
|||||||
|
||||||||
|
|
Thread Tools | Rate Thread | Display Modes |
|
|
|
| Just keep doing. Everything. Keep designing, keep building, keep learning, keep fundraising. Build more robots, try more ideas, compete more and more and more. - [more] |
|
|
|||||||
|
||||||||
|
|
Thread Tools | Rate Thread | Display Modes |
|
#2
08-01-2014, 18:02
|
|||
|
|||
|
Re: CIM Motor Neutral Gear Setting?
If you're looking into a dog shifting setup, the WCP PTO add on kit includes the shifting hardware to shift into a gear, or a sprocket/belt. It was designed for mechanisms requiring shifting/releasing, it interfaces into the PTO, or you can put it into a custom gearbox. The WCP DOG is made of stronger 4140 Steel, and is thicker for more strength, and allows the use of a roll pin to prevent shearing the dog screw.
Links WCP DOG 217-3636 Hopefully this helps |
| Thread Tools | |
| Display Modes | Rate This Thread |
|
|
Threaded Mode