|
Creating a belly pan diamond pattern
I'm trying to figure out the best way to do a aesthetically pleasing 254 style lightening pattern on a belly pan. It seems like the fill pattern tool would be the best for this but I can't find a way to allow the diamonds to be cut by the boundaries (half triangles around the edge).
I also assume that the best way to make a belly pan is first doing the pattern then extruding your electronics mounts?
__________________
2014-2015: FRC 865 Warp7 Team Captain
2016: FRC 865 Mentor
2017: Free Agent Mentor, Inspector
|
It doesn't matter if you write a thousand lines of code for a robot, if you didn't teach and/or inspire the HS students as you did it then you are not a mentor. - JamesBrown [more] 
Threaded Mode