|
Re: 2014 Game Ball Damage
We used the 6" white tread wheels from AM (previous kit wheels) on the outside and 4" kit wheels in the center. We compressed the ball pretty heavily (5-6"?) in testing tho settled in at much less 2-4". We fortunately never popped the ball and we abused it. During testing we approached the ball from many angles and optimized the compression on the ball via the Modulox channel.
As an idea for speed we were using the PG-27 with a 1:1 chain reduction. It was driven at roughly full power in an on/off state. I don't believe there was any coded ramp function.
It sounds like we may have been lucky, but the ball held up well in our testing. The wheels may also have some sharper edges leftover from manufacturing. It may be worth while to radius the edge via sand paper or a file. Also do everything you can to make sure no sharp metal edges are in the vacinity of the ball.
__________________
CO-Founder of Robot in 3 Days and the Robot in 3 Day Challenge.
Last edited by Dan Richardson : 10-01-2014 at 13:18.
|
The game objectives are still the same, get boxes into your scoring zone, stack approximately half of them, run for the top of the ramp.
So lets sit down, shut up, and start building robots. - ChrisH [more] 
10-01-2014, 13:14
Threaded Mode