|
|
|
 Let this be a lesson to everyone to never make changes to manufacturing drawings without issuing a new rev of the drawing itself... - Cory [more] |
 |
|
|||||||
|
||||||||
 |
| Thread Tools |
Rating: 
|
Display Modes |
|
|
|
| Let this be a lesson to everyone to never make changes to manufacturing drawings without issuing a new rev of the drawing itself... - Cory [more] |
|
|
|||||||
|
||||||||
|
| Thread Tools |
Rating:
|
Display Modes |
|
#31
|
|||
|
|||
|
Re: Ball dimensional variability
Can more teams please post their measured ball diameter?
We measured ours with what we felt was robust fill and got 25". We also noticed it shrinks ~0.25" over a few hours. |
|
#32
15-01-2014, 06:28
|
|||
|
|||
|
Re: Ball dimensional variability
We measured our ball shortly after inflating to what we thought was a "normal" inflation, and got 24".
It's since been left overinflated for about a week, and after filling it until the zipper just closes, we measured 25.75". Unlike you guys in the States, though, we've had a week of 90 degree days, so possibly that's a factor. |
|
#33
15-01-2014, 10:25
|
|||||
|
|||||
|
Re: Ball dimensional variability
FWIW: We cannot zip our ball shut if blown up above 26" diameter. It seems underinflated below 25" diameter.
|
|
| Thread Tools | |
| Display Modes | Rate This Thread |
|
|
Linear Mode
