|
|
|
![]() |
|
|||||||
|
||||||||
![]() |
| Thread Tools | Rate Thread | Display Modes |
|
#1
|
|||
|
|||
|
Arm above 60in
If we have an arm that will extend above 60 inches, will the claw on the end of the arm have to be within the 6 inch cylinder requirement throughout the entire game including in the open position?
|
|
#2
|
||||
|
||||
|
Re: Arm
Quote:
Quote:
|
|
#3
|
|||||
|
|||||
|
Re: Arm
First, extending above 60" is only legal in your goalie zone. Just so we're clear that you can't do that all over the field.
Second, yes. Everything that extends above 60" must ALWAYS fit inside a 60" vertical cylinder. |
|
#4
|
||||
|
||||
|
Re: Arm
I may be reading your question wrong but while the appendage is down below 60" it does not have to be within a 6" diameter vertical cylinder as it is not affected by G23 while below the maximum robot height outside of the goalie zone.
|
|
#5
|
||||
|
||||
|
Re: Arm
One thing to keep in mind is that "your" goalie zone (the one where you are allowed to extend above the 60" height) is on the side of your opponents' scoring zone. From your original post it sounded like you were thinking of using a claw to "dunk" the ball in your goal which would not be OK. If I misinterpreted your intent there, please ignore this.
|
![]() |
| Thread Tools | |
| Display Modes | Rate This Thread |
|
|