Cannot Deploy to cRIO

[Peter Cudmore]

One of the things I saw that caused this for one of the new programmers on our team was that for some reason the computer had reset its IP4 back to 198... instead of the 10.xx.yy.05 with xxyy being your team# that you need to connect. Setting that as the ip and the subnet to 255.255.255.0 fixed it

[vps]

Originally Posted by Peter Cudmore

One of the things I saw that caused this for one of the new programmers on our team was that for some reason the computer had reset its IP4 back to 198... instead of the 10.xx.yy.05 with xxyy being your team# that you need to connect. Setting that as the ip and the subnet to 255.255.255.0 fixed it

Yes, our programmers also have had this problem. We have found that teaching students networking and subnetting is very beneficial.

[tomstimac]

My team is having similar problems...

I have a question...in the previous post you mention "macro"..what does that refer to?

The code builds fine and then we use the correct ".out" file...once we start the transfer the status bar pops up saying it is downloading and shows as completed, but when we bring up the driver station it says it is connected but there is no robot code.

We took the previous adivce from above and made sure the CRIO was imaged for C++