|
|
|
 Team handbooks - they are like safety glasses... they seem stupid and a pain to wear, and they make it harder to see... but they seem important about 1 msec after a flaming hunk on metal bounces off them. - Not2B [more] |
 |
|
|||||||
|
||||||||
|
|
Thread Tools |
Rating: 
|
Display Modes |
|
#1
|
|||
|
|||
|
Pneumatic Solenoid Wiring Conundrum
This year we want to use the McMaster-Carr high flow double solenoids part no. 6124K514 found at http://www.mcmaster.com/#catalog/120/1007/=qa3jr8. In the past, our team has used solenoids that require only two pins of electronic input. The electronic input on these particular solenoids is provided by a DIN connector and requires three pins: a hot, neutral, and ground. How/Where would we connect the three pins to the robot? How is it different from connecting the two pin solenoid electrical input?
|
| Thread Tools | |
| Display Modes | Rate This Thread |
|
|
Threaded Mode