Collector RPM

[yash101]

Use your inner engineer and experiment yourself

You'll have more fun (maybe a few more headaches) that way

[Gregor]

A typical rule of thumb is to gear your intakes for a little bit higher of a surface speed than what your drivetrain is geared for. For example if you have geared your drivetrain for 10ft/s, aim for 11-12ft/s surface speed of your rollers. If you can't do the math yourself JVN's mechanical design calculator has an intake section that's really useful.

[Ether]

Originally Posted by Gregor

A typical rule of thumb is to gear your intakes for a little bit higher of a surface speed than what your drivetrain is geared for. For example if you have geared your drivetrain for 10ft/s, aim for 11-12ft/s surface speed of your rollers.

There's a logical reason for this rule of thumb. OP, take a guess?

Hint: it was explained in one of the videos.