|
|
|
 Half your robot could be broken, some drive chains snapped, a drive motor burned out, etc... and your WCD will still be trucking. - AdamHeard [more] |
 |
|
|||||||
|
||||||||
|
|
Thread Tools |
Rating: 
|
Display Modes |
|
|
|
| Half your robot could be broken, some drive chains snapped, a drive motor burned out, etc... and your WCD will still be trucking. - AdamHeard [more] |
|
|
|||||||
|
||||||||
|
|
Thread Tools |
Rating:
|
Display Modes |
|
#6
16-01-2014, 20:37
|
|||
|
|||
|
Re: Robot Reboot?
Not sure about posting the log files, as there are so many and i didn't keep track of the ones in which it happened, but as for the wiring of the Dlink, I think that is a good contender for what the problem may have been. It was wired into a 12 volt connection on the power distribution board, and i did some research and apparently a part that we could not identify was actually a 12 to 5 volt converter, who's purpose is for the Dlink. Am I wrong about that? Would that not be the problem?
|
| Thread Tools | |
| Display Modes | Rate This Thread |
|
|
Threaded Mode