|
|
|
![]() |
|
|||||||
|
||||||||
|
|
Thread Tools | Rate Thread | Display Modes |
|
#2
|
|||||
|
|||||
|
Re: IP Error for cRIO II Imaging
Try holding down the reset button on the cRIO for ~ 10 seconds.
I believe the status light will go solid when you've held the reset button long enough. Then run the cRIO Imaging Tool. You should get a message about being in Safe Mode. When given the choice, choose to reimage. Last edited by Mark McLeod : 18-01-2014 at 20:16. |
| Thread Tools | |
| Display Modes | Rate This Thread |
|
|