|
|
|
A quote from the Southern California Regional Visitors guide:
"If you are having problems the FIRST thing to do is ask your neighbor for help" - ChrisH [more] |
 |
|
|||||||
|
||||||||
|
|
Thread Tools | Rate Thread | Display Modes |
|
|
|
|
A quote from the Southern California Regional Visitors guide:
"If you are having problems the FIRST thing to do is ask your neighbor for help" - ChrisH [more] |
|
|
|||||||
|
||||||||
|
|
Thread Tools | Rate Thread | Display Modes |
|
#4
18-01-2014, 23:26
|
|||
|
|||
|
Re: Relay Outputs on Digital Side Car Not Working
We had a similar problem Monday, code could not turn enable the Spike from the relay output. We are using C++, not LabView.
Problem turned out to be the programmers had upgraded to the new 2014 C++ libraries but did not upgrade the cRIO image to 2014 (it was still at 2013). We were getting very strange NetConsole errors when trying to run the code. After swapping hardware, etc, we begin to focus on the code and then realized the version mismatch. Good luck pin pointing the problem. 
|
| Thread Tools | |
| Display Modes | Rate This Thread |
|
|
Threaded Mode