Vision target location

[goofy173]

Went thru the rules, watched the video, many times. No indication of what that exact measurement is.

[RufflesRidge]

I don't have time to check the drawings now, but there must be a measurement for the width of that piece of polycarb right? The center of the vision target is behind the edge of that polycarb so if you want the measurement to the edge subtract two inches.

[Michael Hill]

Check out the CAD of the field. You should be able to get any measurement you want

[NotInControl]

Originally Posted by Michael Hill

Check out the CAD of the field. You should be able to get any measurement you want

Have you verified this? We too have gone through all of the manuals and videos.

In all cases we have not found clear cut definitions of the measurements to the locations of the vision target.

and how the horizontal and vertical target relate too each other.

If you have clear cut definitions please post them for all.

It would be nice if the center locations of each vision target was defined to say, the center of the goal wall

There is a question on this on the FIRST Q/A

[Michael Hill]

Originally Posted by NotInControl

Have you verified this? We too have gone through all of the manuals and videos.

In all cases we have not found clear cut definitions of the measurements to the locations of the vision target.

and how the horizontal and vertical target relate too each other.

If you have clear cut definitions please post them for all.

It would be nice if the center locations of each vision target was defined to say, the center of the goal wall

There is a question on this on the FIRST Q/A

I'm referring to the actual CAD model of the field. Autodesk has an Inventor Assembly for it (which you can also open in Solidworks)

[dellagd]

Just some warning, I would be wary of using the FRC CAD models as definitive measurements. I know last year the Field CAD model was messed up with the complex pyramid and all. I'd anticipate that it would be better this year, but ya never know.

[goofy173]

I will have one of our CAD guys take a look, but I'm pretty sure he already did.