|
|
|
 Throughout the "FIRST" experience we're all taught that if we try hard we'll achieve some level of success down the road; it hits everyone differently. - nlknauss [more] |
 |
|
|||||||
|
||||||||
 |
| Thread Tools | Rate Thread | Display Modes |
|
|
|
| Throughout the "FIRST" experience we're all taught that if we try hard we'll achieve some level of success down the road; it hits everyone differently. - nlknauss [more] |
|
|
|||||||
|
||||||||
|
| Thread Tools | Rate Thread | Display Modes |
|
#1
|
||||
|
||||
|
2mm key way
My team was wondering how deep to cut a 2mm key way in a 8mm shaft?
Last edited by Christian2443 : 20-01-2014 at 17:10. 
|
|
#2
20-01-2014, 17:39
|
||||
|
||||
|
Re: 2mm key way
Your depth of cut for a key way is always 1/2 the size of the key you are using.
So if you are using a 2mm square key then your depth of cut into the shaft(8mm) should be 1mm.
|
|
| Thread Tools | |
| Display Modes | Rate This Thread |
|
|
Linear Mode
