|
|
|
 I do this stuff because...well first inspired me to become me. I now understand who i am better and what i want to do. - Marygrace [more] |
 |
|
|||||||
|
||||||||
 |
| Thread Tools | Rate Thread | Display Modes |
|
|
|
| I do this stuff because...well first inspired me to become me. I now understand who i am better and what i want to do. - Marygrace [more] |
|
|
|||||||
|
||||||||
|
| Thread Tools | Rate Thread | Display Modes |
|
#1
|
|||
|
|||
|
Deploying Issues
"No CompactRIO devices were found.
Verify an Ethernet connection between the CompactRIO device and this computer, and then turn Windows Firewall off while imaging the CompactRIO device." I don't know what I'm doing wrong. I followed this tutorial almost to the letter. http://wpilib.screenstepslive.com/s/...ging-your-crio 
|
|
#2
22-01-2014, 18:45
|
||||
|
||||
|
Re: Deploying Issues
Do you have other connections on your computer? When I was imaging the cRIO with my laptop I had to disable my wireless and other wired connections, such as virtualbox, for me to deploy correctly.
|
|
#3
22-01-2014, 20:51
|
||||
|
||||
|
Re: Deploying Issues
Are you using a crossover cable or a regular Ethernet? In order to image the RIO you need to use a crossover cable (usually yellow).
 Last edited by Dexterium : 22-01-2014 at 20:54.
|
|
#4
22-01-2014, 21:27
|
|||||
|
|||||
|
Re: Deploying Issues
Did you do the part where screenstepslive mentioned using a network switch between the PC and the cRIO? The DLink works fine for this.
Did you try a different computer? As Kevin mentioned, Disable all other network connections beside the one Ethernet port you are using. Check the Ethernet port address under Advanced to make sure extra IP addresses are not listed. Delete anything that isn't 10.te.am.5
|
|
| Thread Tools | |
| Display Modes | Rate This Thread |
|
|
Linear Mode
