|
|
|
 Instead of arguing about what should have been, learn from the breaks, and celebrate the gracious professionalism being displayed by the other 99% of teams. Word. - PVCMike [more] |
 |
|
|||||||
|
||||||||
 |
|
|
Thread Tools | Rate Thread | Display Modes |
|
|
|
#1
|
|||
|
|||
|
Re: Crio not responding to code deployment
OK. I would be surprised if maxing out the CPU alone would cause this issue. To get technical, it has more to do with thread transitions than CPU usage.
It may be worth checking the Begin and usage for the sensors and solenoids. A missing analog sensor and many other connections will not cause a SW error. In many cases, the SW cannot tell it is missing. The error is more likely due to a mismatch in naming or configuration. Greg McKaskle 
|
|
| Thread Tools | |
| Display Modes | Rate This Thread |
|
|
Hybrid Mode
