|
|
|
 "One man's trash is our robotics team's fundraiser" (We have an aluminum can drive to raise money) - bombadier337 [more] |
 |
|
|||||||
|
||||||||
|
|
Thread Tools | Rate Thread | Display Modes |
|
|
|
| "One man's trash is our robotics team's fundraiser" (We have an aluminum can drive to raise money) - bombadier337 [more] |
|
|
|||||||
|
||||||||
|
|
Thread Tools | Rate Thread | Display Modes |
|
#1
|
||||
|
||||
|
Talons flash red on enable
Today we were planning on having the robot running around but we have hit a bit of a snag. When we enable our robot all of our Talons flash Red which means there is a fault. The only thing we see in the Talon manual is that it could be either low input voltage(checked we get 12 volts at each), over temperature(Cold to the touch) or a shorted output transistor. What can I do to fix this
|
| Thread Tools | |
| Display Modes | Rate This Thread |
|
|
Threaded Mode