|
|
|
 We can't turn off inspiration and recognition, development and learning with a switch. It is an on-going process. If it were not, there would be no need for CD except for 6 weeks out of the year.
- JaneYoung [more] |
 |
|
|||||||
|
||||||||
|
|
Thread Tools | Rate Thread | Display Modes |
|
#3
23-01-2014, 21:51
|
|||||
|
|||||
|
Re: How to easily put riveting holes in a chassis assembly?
You should always create the holes separately in each part file. I highly recommend AGAINST using any assembly level projected/converted sketch geometry, as these are highly prone to breaking references when you iterate and tweak/replace parts. I've lost more time over the years fixing broken references than doing it right the first time, so I hardly ever use projected/converted assembly geometry any more.
|
| Thread Tools | |
| Display Modes | Rate This Thread |
|
|
Threaded Mode