Quote:
Originally Posted by DDSLoan96
Today we were planning on having the robot running around but we have hit a bit of a snag. When we enable our robot all of our Talons flash Red which means there is a fault. The only thing we see in the Talon manual is that it could be either low input voltage(checked we get 12 volts at each), over temperature(Cold to the touch) or a shorted output transistor. What can I do to fix this
|
It just means that the Talons haven't been configured yet. Once you configure them you will see that they will go to a solid orange state on enable.
"Look, it's already weight optimized!" - Samk [more] 
23-01-2014, 21:54
Threaded Mode