|
|
|
![]() |
|
|||||||
|
||||||||
![]() |
| Thread Tools | Rate Thread | Display Modes |
|
#1
|
|||
|
|||
|
Using the TableViewer Application
FIRST provides an application called TableViewer to look at and modify Network Table values on the fly, which they describe here: http://wpilib.screenstepslive.com/s/...rktable-values However, the application that I have looks nothing like the one on ScreenStepsLive, and when I tell it to connect as a client to my robot, it just says, "Disconnected". Do I have the wrong version, or is the documentation out of date? How can I make mine connect to my robot?
|
|
#2
|
||||||
|
||||||
|
Re: Using the TableViewer Application
I agree that the TableViewer look has changed significantly. I didn't have any trouble getting it to connect to the robot as a client. Did you give it the Robot's IP address?
The OutlineViewer is very similar. Have you tried it? |
|
#3
|
|||
|
|||
|
Re: Using the TableViewer Application
I did give it the robot's IP address. What is outlineviewer? I saw it in the folder but didn't know what it was for. Maye I should check it out.
|
|
#4
|
||||||
|
||||||
|
Re: Using the TableViewer Application
It's a slightly fancier version of TableViewer.
|
![]() |
| Thread Tools | |
| Display Modes | Rate This Thread |
|
|