Findings from a couple hours at the lab bench with a CIM and a Jaguar

The robot was spinning, I dont have the energy to spin like that. - Joe Menassa [more]

		Chief Delphi > Technical > Electrical > CAN
Findings from a couple hours at the lab bench with a CIM and a Jaguar

Thread Tools

Rate Thread

Display Modes

#14

29-01-2014, 14:13

zbrozek

Registered User

None #1700

Join Date: Jan 2014

Location: Sunnyvale, CA

Posts: 19

Re: Findings from a couple hours at the lab bench with a CIM and a Jaguar

Agilent DSO7104 and Agilent 33522A, by finding the frequency where it matches my source's 50 ohm output. It was marginally complicated by resonance with the motor's case capacitance at much higher frequencies, but I wasn't fooled.

The measurement was corroborated by direct measurement with an old (early 90s) Fluke LCR meter whose model number I haven't memorized.

« Previous Thread | Portal | Next Thread »

Thread Tools
Show Printable Version Email this Page
Display Modes	Rate This Thread
Switch to Linear Mode Switch to Hybrid Mode Threaded Mode	Rate This Thread:

Posting Rules
You may not post new threads You may not post replies You may not post attachments You may not edit your posts vB code is On Smilies are On [IMG] code is On HTML code is Off

Forum Jump

All times are GMT -5. The time now is 23:59.

The Chief Delphi Forums are sponsored by Innovation First International, Inc.