|
Re: Ball shifter assembly
Quote:
Originally Posted by Jimmy Nichols
We ran into a problem that when we went to mount the gearbox utilizing the 1/4-20 nylocks on one of the sides onto our test base, the bolt cracked the plastic behind the nut. When we went to investigate the nut fell out of place. We aren't sure if this has compromised the gearbox housing or not. For other reasons we have switched gearboxes and have not taken them apart to look into it more.
|
Jimmy,
If you use screws that are too long that would happen, The integrity of the case itself is still intact.
-Aren
__________________
A guy who likes robots.
1625->3928->148->1296->971 oh dear
|
Making a part look pretty even after it is functionaly done can be a very good thing, espically when the part gets cut from the bot and you get to keep it as a trophey. Take pride in your work. - Andy A. [more] 
30-01-2014, 15:27
Threaded Mode