|
|
|
 I have photos of students working the lathe dressed for a concert! Makes me wish for a formal dress night at robotics. - Mark McLeod [more] |
 |
|
|||||||
|
||||||||
|
|
Thread Tools | Rate Thread | Display Modes |
|
|
|
| I have photos of students working the lathe dressed for a concert! Makes me wish for a formal dress night at robotics. - Mark McLeod [more] |
|
|
|||||||
|
||||||||
|
|
Thread Tools | Rate Thread | Display Modes |
|
#2
30-01-2014, 16:43
|
||||
|
||||
|
Re: HELP!! Pneumatics Problems!
Have you Created the references to the Solenoids yet?
Assuming you have, The values you are using are for a Double Solenoid. Make sure you that, when you created the references, you set the solenoids to double. If they are Single Solenoids, Use the On/Off Values. Also, are you sure you are getting data from your joystick? Make sure that you look on the Default Dashboard, under the 2 Graphs in the center, there should be some lights that indicate the button presses. 
|
| Thread Tools | |
| Display Modes | Rate This Thread |
|
|
Threaded Mode