Coding in a sequence. - Chief Delphi

po-nos, cancans, and totes ma goats - dubiousSwain [more]

		Chief Delphi > Technical > Programming > NI LabVIEW
Coding in a sequence.

Thread Tools

Rate Thread

Display Modes

01-02-2014, 16:06

DarthMaulCIS DarthMaulCIS is offline

Registered User

FRC #4607

Join Date: Jan 2014

Location: Becker, Minnesota

Posts: 24

DarthMaulCIS is an unknown quantity at this point

Coding in a sequence.

So in the below picture, I want to make the Restraint Solenoid to retract when I press Button 3(I'll use a Select block). I want the Winch motor to then run a for a set amount after the Restraint is retracted. I assume I need one more frame in the Flat sequence and a Wait command for a few seconds, but I don't know where to go from here. Pictures to go with explanations would be appreciated. Thank you guys.

Attached Thumbnails

Click image for larger version

Name: Sequential Code.jpg
Views: 92
Size: 128.8 KB
ID: 16053

« Previous Thread | Portal | Next Thread »

Thread Tools
Show Printable Version Email this Page
Display Modes	Rate This Thread
Switch to Linear Mode Switch to Hybrid Mode Threaded Mode	Rate This Thread:

Posting Rules
You may not post new threads You may not post replies You may not post attachments You may not edit your posts vB code is On Smilies are On [IMG] code is On HTML code is Off

Forum Jump

All times are GMT -5. The time now is 09:56.

The Chief Delphi Forums are sponsored by Innovation First International, Inc.