Go to Post remember kids, never listen to Big Mike.... - Mike Schroeder [more]
Home
Go Back   Chief Delphi > FIRST > Robot Showcase
CD-Media   CD-Spy  
portal register members calendar search Today's Posts Mark Forums Read FAQ rules

 
 
 
Thread Tools Rating: Thread Rating: 10 votes, 5.00 average. Display Modes
Prev Previous Post   Next Post Next
  #26   Spotlight this post!  
Unread 01-02-2014, 18:53
Caleb Sykes's Avatar
Caleb Sykes Caleb Sykes is offline
Registered User
FRC #4536 (MinuteBots)
Team Role: Mentor
 
Join Date: Feb 2011
Rookie Year: 2009
Location: St. Paul, Minnesota
Posts: 1,059
Caleb Sykes has a reputation beyond reputeCaleb Sykes has a reputation beyond reputeCaleb Sykes has a reputation beyond reputeCaleb Sykes has a reputation beyond reputeCaleb Sykes has a reputation beyond reputeCaleb Sykes has a reputation beyond reputeCaleb Sykes has a reputation beyond reputeCaleb Sykes has a reputation beyond reputeCaleb Sykes has a reputation beyond reputeCaleb Sykes has a reputation beyond reputeCaleb Sykes has a reputation beyond repute
Re: 610 Electronics Board Teaser

First off, this is an absolutely spectacular electronics board. If my team makes one that is 1/3 as good, I will be proud of them. I do have a few questions though:
1. I have always been concerned about having anything in contact the drive motors since they can get very hot. Obviously, since you have wires attached to the top of the CIMs, this is not a concern for you. Do your CIMs not get very hot because of the gearing and/or the load sharing over 3 motors? Or have you tested these motors under high loads for extended periods without seeing any problems with the contacting material.

2. What are those red connectors between the motors and their respective speed controllers? Also, why do you use them instead of cutting the motor wire to length and connecting it right onto the speed controller?

3. Where do you intend to place the remaining pneumatic components? Will there be space directly above the compressor for them?

4. Why did you opt to use the old digital module to sidecar cable instead of the ribbon cable? Is it because of the placement of the sidecar and cRIO right next to each other?

5. Did you cut to length and crimp all of the PWM cables yourself?

6. What is that thing at the top of the PD Board? And why does it have a PWM cable coming out of it?

7. Why are your two non-drive speed controllers attached to 30 amp breakers instead of 40 amp breakers? Are you concerned about the total current draw of 8 40 amp motors?

7. Will there eventually be a mechanism in the space of the 4 compressors? If so, did you design the board specifically to save this space? Or are you just so efficient in your wiring that you have 4 compressors worth of excess space just to show off?
 


Thread Tools
Display Modes Rate This Thread
Rate This Thread:

Posting Rules
You may not post new threads
You may not post replies
You may not post attachments
You may not edit your posts

vB code is On
Smilies are On
[IMG] code is On
HTML code is Off
Forum Jump


All times are GMT -5. The time now is 01:29.

The Chief Delphi Forums are sponsored by Innovation First International, Inc.


Powered by vBulletin® Version 3.6.4
Copyright ©2000 - 2017, Jelsoft Enterprises Ltd.
Copyright © Chief Delphi