|
Re: Build Blitz Robot Reveal - Team JVN
Aren had told me the other week that they milled a couple of grooves into the face of the gear (after milling the face of the gear flat to avoid contact with the choo-choo linkage). They then drilled a hole through the hex shaft and used a roll pin to retain the gear by using the grooves milled into the face of the gear.
__________________
1625 Winnovation Member: 2005-07
1625 College Mentor: 2007-11
525 Swartdogs Mentor: 2011-12
1746 OTTO Lead Mentor: 2013-Present
|
:( The Internet just ate my post. - Greg Marra [more] 
02-02-2014, 11:08
Threaded Mode