|
|
|
 After talking with the students on these teams I could see the light in their eyes. These were their robots! Inspired? That would be a definate YES! - Steve W [more] |
 |
|
|||||||
|
||||||||
|
|
Thread Tools | Rate Thread | Display Modes |
|
|
|
| After talking with the students on these teams I could see the light in their eyes. These were their robots! Inspired? That would be a definate YES! - Steve W [more] |
|
|
|||||||
|
||||||||
|
|
Thread Tools | Rate Thread | Display Modes |
|
#7
04-02-2014, 13:33
|
||||
|
||||
|
Re: Motor controlled by Talon won't turn off
Is the motor spinning 100% speed or just slow? If they're going 100%, its probably code, which is outside my knowledge range.
If they're just spinning slow or pulsing, I'd recommend doing a calibration of the Talons. The calibration procedure can be found on page 7 of http://crosstheroadelectronics.com/T...Manual_1_2.pdf |
| Thread Tools | |
| Display Modes | Rate This Thread |
|
|
Threaded Mode