|
|
|
 Swerve Drive (n.) - a set of mechanisms to ensure the robot will sit dead on the field for half of that robot's first event - Kevin Leonard [more] |
 |
|
|||||||
|
||||||||
 |
|
|
Thread Tools | Rate Thread | Display Modes |
|
|
|
| Swerve Drive (n.) - a set of mechanisms to ensure the robot will sit dead on the field for half of that robot's first event - Kevin Leonard [more] |
|
|
|||||||
|
||||||||
|
|
|
Thread Tools | Rate Thread | Display Modes |
|
|
|
#2
07-02-2014, 17:50
|
||||
|
||||
|
Re: How to Use a Manifold
VABM-L1-105-G18-4
Mat. -Nr.: 566560 Serie: D902 it holds solenoid VUVG-L10-B52-T-M7-1P3 i don't know if it matters...but on the three tube connecters for the manifold to connect to the pneumatic tubing...it's number 1 in the middle and then 3 and 5 on the sides |
|
#3
07-02-2014, 20:13
|
|||
|
|||
|
Re: How to Use a Manifold
The center port supplies air and the ports on either side of it are the venting holes for the valves that are mounted. I think the holes are repeated on each side of the manifold. If so, plug the center one on the far side unless you are supplying air to another solenoid or mounting pad from it.
|
|
| Thread Tools | |
| Display Modes | Rate This Thread |
|
|
Hybrid Mode
