Positioning two connected motors

Give me a week, and a lot of caffeine and I could have one made. Problem is the lack of a week and caffeine. - Mike [more]

		Chief Delphi > Technical > Programming > NI LabVIEW
Positioning two connected motors

Thread Tools

Rate Thread

Display Modes

08-02-2014, 11:38

timetravel_1024 timetravel_1024 is offline

Registered User

FRC #0839

Join Date: Jan 2014

Location: United States

Posts: 2

timetravel_1024 is an unknown quantity at this point

Re: Positioning two connected motors

Hi DonRotolo,

Thank you for your reply! We are unable to use a Y cable because the rules state that we may only have one motor per controller for the motors we are using. However, we've decided to cut back to one motor in order to be able to use the built in CAN functions for positioning.

« Previous Thread | Portal | Next Thread »

Thread Tools
Show Printable Version Email this Page
Display Modes	Rate This Thread
Switch to Linear Mode Switch to Hybrid Mode Threaded Mode	Rate This Thread:

Posting Rules
You may not post new threads You may not post replies You may not post attachments You may not edit your posts vB code is On Smilies are On [IMG] code is On HTML code is Off

Forum Jump

All times are GMT -5. The time now is 21:02.

The Chief Delphi Forums are sponsored by Innovation First International, Inc.