|
|
|
 In the end, if our products are crap, then people will not buy them. This is the risk of doing business, and the foundation of capitalism. - Andy Baker [more] |
 |
|
|||||||
|
||||||||
|
|
Thread Tools | Rate Thread | Display Modes |
|
|
|
| In the end, if our products are crap, then people will not buy them. This is the risk of doing business, and the foundation of capitalism. - Andy Baker [more] |
|
|
|||||||
|
||||||||
|
|
Thread Tools | Rate Thread | Display Modes |
|
#3
10-01-2002, 21:30
|
|||||
|
|||||
|
Gearing up...
I have two questions.
#1: What is the diameter of the gear required to get the Black Motor to a free speed of 20000 rpm to match the drill? #2: Can the drill motor without transmission handle side loads? Thanks in advance. |
| Thread Tools | |
| Display Modes | Rate This Thread |
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| drill motor gear noise | arshacker | Motors | 2 | 04-02-2003 19:52 |
| "Motors and Drive train edition" of Fresh From the Forum | Ken Leung | CD Forum Support | 6 | 29-01-2002 12:32 |
| Black motor mating gear | mnkysp6353 | Motors | 5 | 20-01-2002 11:09 |
| the motor mount with gear switch | newatthis | General Forum | 4 | 15-01-2002 22:07 |
| Drivetrain Help | Jordan | Technical Discussion | 16 | 02-12-2001 12:14 |
Threaded Mode