Problem connecting to the CRIO

[silas13579]

So far, connecting directly to the CRIO actually has been working, so we're just going off of that right now. The bridge config utility isn't working on our radio. It says login failed.

[Zmarken]

Originally Posted by silas13579

So far, connecting directly to the CRIO actually has been working, so we're just going off of that right now. The bridge config utility isn't working on our radio. It says login failed.

If deploying directly through the cRIO is working, then I'm pretty sure it's a router issue.

I'd say you should do a factory reset of the router, then go through the Bridge Configuration tool again. If you're using the router in the KoP, reset it by holding down the reset button in the back of the router for ~10 seconds.

Try that, and see what your results are.