CIM motors vibrate/jitter

[cgmv123]

Originally Posted by Wzup4021

We don't have any wheels hooked up to it, as it is just on a C-channel frame. When we enable it, the lights on the Talons flicker between red and orange. When it is disabled, they don't jitter.

It's (most likely) a code issue. Red means the Talon is getting a reverse signal, while orange means the Talon is getting a neutral signal. If it's bouncing between the two, it's most likely caused by a code issue, but you can try calibrating the Talons as well.

[Wzup4021]

Although possible, I don't believe so. We've sent it code that had no other commands other then to set the motors to 0. It still bounces back and forth several times a second between the two colors.

[dellagd]

Originally Posted by Wzup4021

Although possible, I don't believe so. We've sent it code that had no other commands other then to set the motors to 0. It still bounces back and forth several times a second between the two colors.

Are you routing your PWM wires parallel with all of your power wires to the motors? The induced current could mess with the signal, but if you're not running them I doubt this would occur. Just controls food for thought.

That being said, do calibrate them. If the calibration is such that a zero signal is right on the line in the talon of neutral/reverse, it would probably bounce between them as you said.

[Wzup4021]

Well, we have the PWM wires tied next to eachother most of the way until they split, and one place that could be a problem is I looped them up at one point to shorten them up, just a simple back and around loop, but could that be the issue?

[dellagd]

Originally Posted by Wzup4021

Well, we have the PWM wires tied next to eachother most of the way until they split, and one place that could be a problem is I looped them up at one point to shorten them up, just a simple back and around loop, but could that be the issue?

Having the PWMs next to each other wouldn't be an issue, just big current flow through the power wires from the PDB.

http://www.crosstheroadelectronics.c...Manual_1_1.pdf - Pg 7 is the calibration instructions.

[Al Skierkiewicz]

It is very possible that something is telling the Talons to go full throttle and in doing so they trip the breaker feeding each one. Do you have any wiring attached to the output of the Talons? Double check this to be sure you don't have a short there.

[Wzup4021]

Yes, we have wiring. They are not making contact though, it's circle screw on connectors connected to wire running straight to the CIMs, no metal contact.

[cgmv123]

Originally Posted by Wzup4021

Although possible, I don't believe so. We've sent it code that had no other commands other then to set the motors to 0. It still bounces back and forth several times a second between the two colors.

Something is causing the mixed signal and thus the jitter. Check your DSC connections.

[Wzup4021]

All of the DSC connections are proper. We disconnected them all and reconnected them.